Underpinning advice
Sunken driveway: lift it, or replace it?
Published
A driveway that has dropped at the garage, or a path with a lip you keep catching your toe on, usually produces the same first reaction: get it fixed, whatever that takes. The useful question is a cheaper one — does “fixed” mean lifting the existing concrete back to level, or pulling it out and pouring new? Both are legitimate answers depending on what’s actually gone wrong, and the gap between them is real money. Getting the decision right starts with understanding why Melbourne driveways sink in the first place, because the cause decides the fix more than the symptom does.
The concrete is rarely the problem
In the overwhelming majority of jobs we see, the slab itself is perfectly sound. What’s changed is the ground underneath it. Four causes account for almost all of it:
- Poorly compacted fill. Very common across the growth-corridor estates, where sites were cut and filled during subdivision to turn undulating farmland into flat, buildable lots. Fill settles unevenly for the first five to fifteen years, and a driveway poured on top of it goes down with it.
- Escaping stormwater. A cracked stormwater line, a disconnected downpipe, or a downpipe simply discharging straight onto soil beside the slab washes the fine particles out of the ground and leaves a void underneath. This is the single most common cause, and the most important one to find before doing anything else.
- Reactive clay shrinking. Through a dry Melbourne summer, clay under an unshaded driveway loses moisture and contracts, and the slab drops with it. In the western and south-eastern growth corridors this can partly reverse over a wet winter, which is why some driveways appear to move with the seasons rather than simply getting worse.
- Service trenches. Water, sewer and gas trenches dug and backfilled during construction, if not compacted properly, leave a soft line running under the slab — and the slab cracks and dips along exactly that line, often visible as a straight depression crossing the driveway at a consistent angle.
Tree roots get blamed more often than they’re actually responsible. They can contribute, particularly to physical heaving where a root runs directly under a slab edge, but in our experience they’re a less common actual cause than the four above.
Why the water question comes before either repair
Whichever fix you choose, fixing the level without fixing what caused the level to go in the first place is money that doesn’t last. This matters more for lifting than for replacement, because lifting is specifically a soil correction — it fills the void and compacts the ground, then raises the slab on top of it. If a stormwater leak is still running under there, it keeps washing the fill out from under the newly lifted slab, and the driveway sinks again within a season or two, not because the resin failed but because the water never stopped. Replacement doesn’t dodge this either: a new slab poured over the same unresolved leak will eventually show the same crack in the same place.
So the honest order of operations is: find the water first. That usually means checking the downpipes and where they actually discharge, looking at the fall of the ground immediately around the slab, and — where a leak is suspected rather than obvious — a CCTV drain inspection and a static water test, which cost a few hundred dollars and routinely settle the question outright. Only once the moisture source is dealt with does it make sense to spend on raising or replacing the concrete itself.
When lifting is the right call
Polyurethane resin injection is the better answer for the majority of sunken driveways we’re asked to look at. Small holes are drilled through the slab on a grid, expanding resin is pumped in, and it fills the void, compacts the loose soil around it, and lifts the slab back toward level — all without breaking anything out. Most residential driveways are back in service the same day, often within hours.
It suits a slab that has sunk but is still structurally intact: cracked into one or two large pieces at most, with the reinforcing mesh still doing its job of holding those pieces together as a unit. Lifting raises the whole piece together, closing the crack rather than stepping it. It’s also, on the published figures for this kind of work, usually about half to two-thirds the cost of breaking out and repouring, and the gap widens on larger driveways or anywhere access for a truck and excavator is tight — which describes most of the growth-corridor estates, where driveways sit close to the boundary fence with no room to manoeuvre.
When replacement is the honest answer
Lifting has a real limit, and it’s worth knowing where it sits rather than finding out halfway through a job. A slab that has cracked into many small pieces, rather than one or two large ones, has lost the stiffness to come up as a unit — pushing resin underneath it just as likely cracks it further as lifts it evenly. The same applies where the steel reinforcement inside has corroded through: without intact mesh tying the pieces together, there’s nothing for the resin to lift against. In both cases, replacement is the straightforward recommendation, and a contractor who tells you that rather than attempting a lift anyway is doing you a favour, not talking themselves out of a smaller job.
Replacement also wins when you’re planning to change the driveway anyway — widening it, changing the fall to solve a drainage problem properly rather than just raising the symptom, or matching a different finish. In that situation the extra cost of a new pour is buying you something lifting can’t.
Where we see this most
Driveway settlement clusters heavily in the growth-corridor estates, for reasons that track the causes above almost exactly. Tarneit and Truganina were built on cut-and-fill lots carved out of farmland within the last fifteen years, and a driveway poured across the join between undisturbed ground and engineered fill is a near-textbook case for uneven settlement. Point Cook sits flat and low with a comparatively high water table, which means a leaking stormwater or sewer line there saturates the ground for longer than it would on better-draining soil, and that’s usually the first thing worth checking. Caroline Springs carries highly reactive basalt clay now twenty-plus years into its seasonal swell-and-shrink cycle, so a driveway with no shade and a hot northern exposure can show real seasonal movement that a driveway two streets over, in more shelter, does not.
None of that changes the decision framework — water first, then lift if the slab is sound, replace if it isn’t — but it does explain why these are the suburbs where we get asked the question most often.
If the house is moving too
A sunken driveway is its own problem and doesn’t automatically mean anything structural is happening to the house. But if the same frontage is also showing new cracking above windows or doors, or a door that’s started binding at the top, that’s a different and larger conversation. Lifting or replacing a driveway while the house behind it is still moving fixes the least important part of the picture first. See our underpinning page for what that assessment involves, and get the house looked at alongside the driveway rather than afterwards.
Not sure which one your driveway needs? Book a free on-site assessment — we’ll check the fall, look for the water source, and give you a straight answer on lifting versus replacement, including telling you honestly when the cheaper option won’t hold.
Common questions
Will my driveway just sink again after it's lifted?
Only if the reason it sank in the first place is still happening. The resin itself doesn't degrade, so a lifted slab stays lifted unless the ground underneath it moves again. That's why a competent assessment looks for the water source — a cracked stormwater pipe, a downpipe discharging onto soil instead of into drainage, garden beds watered daily against the edge of the slab — before quoting the lift. Fix the cause and the lift holds. Lift over an active leak and you've bought yourself a year, maybe two, before you're back where you started.
How do I know if my driveway has sunk or if it was just built that way?
Check the fall. A driveway is supposed to have a slight slope, usually falling away from the garage towards the street or a drainage point, so water runs off rather than pooling. Sunk sections show up as a change in that fall — a dip you can see water collect in after rain, a lip at a joint where one slab sits lower than its neighbour, or a visible gap where the slab has pulled away from the garage apron or the house. A driveway with a consistent, even fall along its whole length, even if that fall looks more pronounced than you'd like, was probably built that way and isn't a sign of settlement.
Does a sunken driveway mean my house footings are at risk too?
Not usually, but it's worth ruling out rather than assuming. A driveway is an isolated slab on its own footing or none at all, so it can sink from fill settlement or a leaking stormwater line without anything happening to the house. The exception is when the same cause reaches both — a leak running under the boundary between driveway and house slab, or reactive clay affecting the whole frontage. If the driveway has dropped and you're also seeing new cracking in the house itself, particularly above windows and doors, that's a different and bigger conversation than the driveway alone, and it's worth having a look at both together before committing to either repair.
Think this is happening at your place?
We assess before we quote — floor levels measured, cracks mapped, and a straight answer on whether you need work at all. Read more aboutunderpinning & foundation repair, or get in touch.