Rising damp advice
Your building report found high moisture readings — what now?
Published
You have just bought, or are about to buy, an older Melbourne house. The building and pest report has come back, and under “major defects” there is a line like: abnormally high moisture readings were detected on lower wall areas — contact a damp proofing specialist to ascertain cause.
It sounds alarming. Often it is not. That line is the inspector handing the question on to someone else, and the answer is often a lot cheaper than “rising damp” suggests. Here is how to read it, and what to do in what order.
What the inspector actually measured
Pre-purchase inspections under AS 4349.1 are visual and non-invasive. For damp, that usually means a hand-held moisture meter pressed against the plaster at the base of the walls in each room.
Those meters are useful, but they are blunt. They read high when there is water in the wall, and they also read high when there is:
- Salt in the plaster. Old damp leaves hygroscopic salts behind, and those salts pull moisture out of the air. A wall that dried out years ago can still read wet.
- Foil or metal behind the surface. Foil-backed plasterboard, metal corner beads and pipes all push the reading up.
- Cold surfaces in winter. Condensation on the base of an external wall is real moisture, but it is a ventilation problem, not rising damp.
That is why a careful report words it as possible rising damp, with further investigation required. Most reports also say “no evidence of paint or wall deterioration”. Read that line closely. Genuine long-term rising damp nearly always shows visible damage: a tide mark, salt crusting, paint bubbling or plaster crumbling at the base of the wall. High readings with no visible damage point more often to something else.
The usual causes, roughly in order of how often we find them
- Bridged damp course. A garden bed, path, render or built-up soil sitting above the damp proof course lets moisture walk straight past it. This is extremely common in inner-city houses where the front garden or side path has been raised over the decades. The fix is usually lowering the ground or cutting the render back, not chemical injection.
- Poor subfloor ventilation. Vents painted over, blocked by paving, or never enough to begin with. The air under the floor stays damp, and that dampness rises into the base of the walls and the timbers. Inspectors list “poor sub floor ventilation” as a possible cause because they so often find it.
- Water that has nowhere to go. Downpipes discharging at the base of the wall, missing gutters, paving falling toward the house. If the readings are worst near a downpipe or a corner, start there.
- Plumbing leaks. High readings near a shower, bath or laundry trough usually point to the wet area, not the ground. That is a plumber’s job first: a leak test, then waterproofing if needed.
- Genuine rising damp. A failed or missing damp course in solid brick or bluestone walls, with water wicking up from the ground. It happens, especially in Victorian-era houses. But it is the last explanation to reach for, not the first.
Our rising damp page covers how to tell these apart and what each fix costs.
When the report also mentions the floors
This is where buyers tend to miss the bigger picture. If the same report mentions uneven floors, springy or bouncy floors, or no subfloor access, the damp and the floors are probably the same story.
Water under a house does two things at once. It keeps the base of the walls wet, and it rots timber stumps, bearers and joists. A springy floor in the hallway or kitchen often means decayed or loose timber underneath. An uneven floor in a front room often means stumps that have sunk or rotted. A report that says “no subfloor access to assess the condition of stumps” is telling you nobody has looked yet.
So the order matters:
- Get under the house first. If there is no access, have a small hatch made. Without it, nobody can diagnose the damp or the floor properly.
- Find where the water comes from before treating anything. Fixing ventilation and drainage protects the stumps as well as the walls, and it is the cheapest work on the list.
- Then deal with the structure. Once the subfloor is visible you will know whether you need packing, a few replacement stumps or a full restump. Our guide to the signs your house needs restumping explains what each symptom points to.
If a wall looks bowed and the report also lists settlement cracks outside, read wall cracks: when to worry and our leaning walls page. A bulge with no stair-step cracking is usually failed wall ties, not foundations, and that changes the repair completely.
Who to call, and in what order
| Report finding | Call first | Why |
|---|---|---|
| High readings near a shower, bath or laundry | Licensed plumber | Rule out a leak before anything else |
| High readings at the base of walls, no visible damage | Damp specialist who also checks drainage and ventilation | The cause is often outside or under the house |
| Tide marks, salt crusting, crumbling plaster | Damp specialist | Genuine rising damp is likely |
| Uneven or springy floors, no subfloor access | Restumping contractor | Someone needs to see the stumps |
| Settlement cracks to monitor | Monitor for a season, then a structural engineer if they widen | Most settlement cracks are old and stable |
Be wary of anyone who quotes a chemical damp course without looking under the house, checking the ground levels outside, or asking where the downpipes go.
What it typically costs
Fixing ventilation and drainage (lowering garden beds, unblocking or adding vents, redirecting downpipes) usually runs $300 to $1,500. That resolves a large share of the houses we see flagged in reports. An injected chemical damp course on a wall that genuinely needs one costs roughly $2,500 to $8,000 on a typical house, plus replastering. Subfloor and stump work is priced separately once someone has looked. See our costs page for the full ranges.
Send us the report
If you have a building and pest report, the quickest way to get a useful answer is to email it to quote@foundationrepairsmelbourne.com.au with your address and a phone number. We will read it before we call, so the first conversation is about your house rather than a generic checklist.
Common questions
Does a high moisture reading in a building report mean the house has rising damp?
No. It means a non-invasive meter read higher than expected at that spot on the day. Pre-purchase inspectors usually use a hand-held moisture meter pressed against the plaster, and those meters respond to salt, foil-backed plasterboard and metal behind the wall as well as to water. That is why most reports word it carefully — 'possible rising damp, further investigation required' — and list condensation, poor subfloor ventilation, leaks and drainage as other likely causes. The reading tells you where to look. It does not tell you what is wrong.
The report says there was no subfloor access. Is that a problem?
It is a gap rather than a problem in itself, but it matters because the subfloor is where damp and stump issues usually start. Plenty of Victorian and Edwardian houses in the inner north were built without an access hatch, so the inspector could only judge the floor from above. If the report also mentions uneven or springy floors, the sensible next step is to have an access point made, typically a small hatch cut neatly into a wardrobe or cupboard floor, so someone can actually look at the stumps, bearers, ground moisture and vents.
Can I negotiate or claim on damp found in a pre-purchase report?
That depends on where you are in the purchase and on your contract, so check with your conveyancer or solicitor before relying on it. Before settlement, a specialist's written assessment and quote is far more useful in any conversation with the vendor than the building report alone, because it turns a vague 'further investigation required' into a known cost. After settlement, the report becomes your starting brief for the repair. Either way, get the cause diagnosed first. A quote for a chemical damp course on a wall that is actually wet from a garden bed is not evidence of anything.
Think this is happening at your place?
We assess before we quote — floor levels measured, cracks mapped, and a straight answer on whether you need work at all. Read more aboutrising damp treatment, or get in touch.